diff -aurp open-iscsi-2.0-737/etc/iscsid.conf open-iscsi-2.0-737.work/etc/iscsid.conf
--- open-iscsi-2.0-737/etc/iscsid.conf 2006-11-22 14:21:17.000000000 -0600
+++ open-iscsi-2.0-737.work/etc/iscsid.conf 2006-11-24 16:26:17.000000000 -0600
@@ -14,8 +14,8 @@
# To request that the iscsi initd scripts startup a session set to "automatic".
# node.startup = automatic
#
-# To manually startup the session set to "manual". The default is manual.
-node.startup = manual
+# To manually startup the session set to "manual". The default is automatic.
+node.startup = automatic
# *************
# CHAP Settings
diff -aurp open-iscsi-2.0-737/README open-iscsi-2.0-737.work/README
--- open-iscsi-2.0-737/README 2006-11-22 14:32:55.000000000 -0600
+++ open-iscsi-2.0-737.work/README 2006-11-24 16:38:37.000000000 -0600
@@ -303,19 +303,10 @@ option. For example this would mount a i
/dev/sdb /mnt/iscsi ext3 _netdev 0 0
-SUSE or Debian:
----------------
-Otherwise, if there is a initd script for your distro in etc/initd that
-gets installed with "make install"
-
- /etc/init.d/open-iscsi start
-
-will usually get you started.
-
-Other:
+Manual:
------
-If there is no initd script, you must start the tools by hand. First load the
-iscsi modules with:
+If there is no initd script or you wish to run iscsi manually, you must start
+the tools by hand. First load the iscsi modules with:
modprobe -q iscsi_tcp
@@ -358,8 +349,6 @@ storage), it is better to automate the l
3. automate target logins for future system reboots
---------------------------------------------------
-Note: this may only work for Red Hat, Fedora and SUSE configurations
-
To automate login to a node, use the following with the record ID of the
node discovered in the discovery above:
iscsiadm -m node -T targetname -p ip:port --op update -n node.conn[0].startup -v automatic
@@ -372,7 +361,6 @@ all sessions add the following to the /e
To login to all the automated nodes, simply restart the iscsi service
e.g /etc/init.d/open-iscsi restart
-
8. TBD
======